Forum

When you are in the application, what version of XI do you see in the bottom corner. If you are in 2024R1.4.4 then that license no longer works.

Hey datagnan, sorry that you are running into this issue. The CSP50 license is entering an expired state so that may be causing the issue you are runn...

@travis-bean Thanks for bringing that to our attention. I'll make a note of it and notify the team tracking our documentation that needs updating. In ...

Hey Travis,The error is saying that you have a duplicate contactgroup for admins. If you look in your contactgroups.cfg file admins should be set up a...

Hey RudyM88, with CSP you will have a GUI and wizards you can run through to add these hosts and services so you wont have to touch the CLI.

@jafferkhan Hey, I am talking with our build team to look into the issue more to see what could cause it. It may take some time to figure out and ther...

For the level of support with a step by step basis it may be best for you to open up a ticket with support. You can do so here.

You can also try restarting the vm and see if that fixes it. Otherwise there may be something weird with your vmware setup that is causing it to not h...

Hey Jafferkhan,Hm not good, I will bring this up to our build process to see what could be happening. If you log in and run the command below, can you...

Hey jchambers77, this forum is meant for csp support, so you might be able to find better support here. If you aren't very knowledgeable with linux ...

Hey, there are several different license levels for CSP. There is only one tier of free version and its for non commercial use at 50 nodes. For our pa...

Hey rleejr,this may not be the correct location for that question to get traction. This forum topic is about csp, so looking for alternatives here isn...

You can delete the services you don't care to have by going to Configure -> Core Config Manager and then under the monitoring section. From there f...

@rleejr The CSP install and the XI install are the same process, I know its confusing. Did you try the install and have issues with it following the p...

This is resolved now, sorry for the delay.